CGYMQ - N(2),N(2)-DIALLYLMELAMINE, D1075
- MSDS: CGYMQ
- Manufacturer: TCI AMERICA
- Product Name: N(2),N(2)-DIALLYLMELAMINE, D1075
- National Stock Number: 6810-00N078765
Product Identification
Product ID:N(2),N(2)-DIALLYLMELAMINE, D1075
MSDS Date:09/04/1996
FSC:6810
NIIN:00N078765
MSDS Number: CGYMQ
Responsible Party
PORTLAND, OR 97203
US
Emergency Phone: 800-424-9300 (CHEMTREC)
Info Phone: 800-423-8616
Cage: 041D5
Contractor
Telephone: 800-423-8616
Cage: 041D5
Ingredients
N(2),N(2)-DIALLYLMELAMINE
CAS: 91-77-0
Fraction By Weight: 98%
OSHA PEL N/K
ACGIH TLV: N/K
RESUSCITATION. LOOSEN TIGHT CLOTHING SUCH AS COLLAR,
RTECS: 9999999ZZ
ADMINISTERED. SEEK MED ATTN IF RESP PROBLEMS DO NOT
RTECS: 9999999ZZ
PERSON DRINK SEVERAL GLASSES OF WATER/MILK. INDUCE
RTECS: 9999999ZZ
VOMITING WILL NOT REENTER MOUTH & THROAT. NEVER GIVE
RTECS: 9999999ZZ
LIMITS. IF USER OPERATIONS GENERATE DUST, FUME/MIST,
RTECS: 9999999ZZ
EXPOSURE LIMIT.
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:SLIGHTLY DANGEROUS TO DANGEROUS
IN CASE OF SKIN CONTACT (IRRITANT), OF INGESTION, OF INHALATION.
THIS PRODUCT MAY CAUSE SKIN AND EYE IRRITATION. CHRONIC:NONE LISTED
BY MANUFACTURER.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE KNOWN.
First Aid
First Aid:EYE CONT:CHECK FOR & REMOVE ANY CONT LENSES. DO NOT USE EYE
OINTMENT. FLUSH W/RUNNING WATER FOR @ LST 15 MINS, OCCASNLY LIFTING
UPPER & LOWER EYELIDS. SEEK MED ATTN. SKIN CONT:IF CHEM GETS
SPILLED ON CLOTHED PORTION OF BODY, REMOVE CONTAMDCLOTHES AS
QUICKLY AS POSS, PROTECTING HANDS & BODY. PLACE VICTIM UNDER DELUGE
SHOWER. IF CHEM TOUCHES VICTIM'S EXPOSED SKIN, SUCH AS HANDS:GENTLY
& (SUPDAT)
Fire Fighting
Flash Point:COMBUSTIBLE
Extinguishing Media:SMALL FIRE:USE DRY CHEMICALS, CO*2, WATER SPRAY OR
FOAM. LARGE FIRE:USE WATER SPRAY, FOG OR FOAM. DO NOT USE WATER
JET.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:COMBUSTION PRODUCTS ARE TOXIC CARBON
OXIDES (CO, CO*2), NITROGEN OXIDES (NO, NO*2).
Accidental Release
Spill Release Procedures:ALWAYS SHUT OFF ANY SOURCES OF IGNIT,
VENTIALTD AREA, & EXERCISE CAUTION. USE SHOVEL TO PUT MATL INTO
CONVENIENT WASTE DISP CNTNR. FINISH CLEANING SPILL BY RINSING ANY
CONTAMD SURFACES WITH COPIOUS AM OUNTS OF WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:STORE AWAY FROM HEAT & SOURCES OF
IGNIT. MECH EXHAUST REQD. WHEN NOT IN USE, TIGHTLY SEAL CNTNR &
STORE IN DRY, COOL PLACE. AVOID CONT W/SKIN & EYES.
Other Precautions:AVOID EXCESS HEAT & LIGHT. DO NOT BREATHE DUST. IN
CASE OF INSUFFICIENT VENT, WEAR SUITABLE RESP EQUIP. IF FEEL
UNWELL, SEEK MED ATTN & SHOW LABEL WHEN POSS. ALWAYS STORE AWAY
FROM INCOMPAT CMPDS SUCH AS OXIDIZING AGENTS, ACIDS.
Exposure Controls
Respiratory Protection:A NIOSH APPROVED RESPIRATOR SHOULD BE USED TO
AVOID INHALATION OF THE PRODUCT.
Ventilation:USE PROCESS ENCLOSURES, LOC EXHAUST VENT/OTHER ENGINEERING
CONTROLS TO KEEP AIRBORNE LEVELS BELOW REC EXPOSURE (ING 6)
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EYE WASH & DELUGE SHOWER . LAB
COAT. NIOSH APPRVD DUST RESP. BOOTS.
Work Hygienic Practices:SUGGESTED PROT CLTHG MIGHT NOT BE SUFFICIENT;
CONSULT A SPECIALIST BEFORE HANDLING THIS PRODUCT.
Supplemental Safety and Health
FIRST AID PROC:THOROUGHLY WASH CONTAMD SKIN W/RUNNING WATER &
NON-ABRASIVE SOAP. BE PARTICULARLY CAREFUL TO CLEAN FOLDS,
CREVICES, CREASES & GROIN. COVER IRRITATED SKIN W/EMOLLIENT. IF
IRRIT PERSISTS, SEEK MED ATTN. WASH ANY CONTAMD CLTHG BEFORE
REUSING. INHAL:IF VICTIM IS NOT BRTHG, PERFORM MOUTH-TO-MOUTH (ING
2)
Chemical Properties
Melt/Freeze Pt:M.P/F.P Text:288F,142C
Evaporation Rate & Reference:NOT KNOWN
Solubility in Water:NOT KNOWN
Appearance and Odor:SOLID. (CRYSTALLINE POWDER.)
Stability
Stability Indicator/Materials to Avoid:YES
HIGHLY REACTIVE WITH OXIDIZING AGENTS, ACIDS.
Stability Condition to Avoid:AVOID EXCESSIVE HEAT AND LIGHT.
Hazardous Decomposition Products:THESE PRODUCTS ARE TOXIC CARBON OXIDES
(CO, CO*2), NITROGEN OXIDES (NO, NO*2).
Disposal
Waste Disposal Methods:RECYCLE TO PROCESS, IF POSS. CONSULT
LOCAL/REGIONAL AUTH. MAY BE ABLE TO DISSOLVE/MIX MATL W/COMBUST
SOLV & BURN IN CHEM INCIN EQUIPPED W/AFTERBURNER & SCRUBBER SYS.
OBSERVE ALL FEDERAL, STATE, AND LO CAL REGS WHEN DISPOSING OF THIS
SUBSTANCE.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.